Artesyn COMX-P2020 BSP User Guide (July 2014) - Manual (Page 34)

BSP Build Environment
COMX-P2020 BSP User Guide (6806800L84B) 34
+ echo done.
done.
cp /tmp/percy/rootfs_nfs.tar.gz /local/tftpboot/COMX-
P2020/current/rootfs-nfs.tar.gz
make[1]: Leaving directory `/home/percy/p2020/linux/fs'
[percy@localhost p2020]$
2. If successful, the rootfs-nfs.tar.gz can be found at the output directory:
[percy@localhost p2020]$ ls -al /local/tftpboot/COMX-
P2020/current/rootfs-nfs.tar.gz
-rw-r--r-- 1 percy percy 200279316 Dec 13 11:50
/local/tftpboot/COMX-P2020/current/rootfs-nfs.tar.gz
[percy@localhost p2020]$
4.3.6 Build release package for COMX-P2020
1. The release package of COMX-P2020 includes not only COMX-P2020.bsp.tar.gz, but also
the 4M U-boot Image for SPI flash which will be used at factory to program the SPI flash.
Before building the release package, make sure that all the above BSP targets should be
build in advance.
[percy@localhost p2020]$ make release
./make_spi_image.sh /local/tftpboot/COMX-P2020/current
4+0 records in
4+0 records out
4194304 bytes (4.2 MB) copied, 0.0185468 seconds, 226 MB/s
1026+0 records in
1026+0 records out
525312 bytes (525 kB) copied, 0.0113922 seconds, 46.1 MB/s
/local/tftpboot/COMX-P2020/current/u-boot.bin create OK.
./make_bsp_package.sh /local/tftpboot/COMX-P2020/current
cp: cannot create regular file `/local/tftpboot/COMX-
P2020/current/./make_sd.sh': Permission denied
make_sd.sh
u-boot-spi.bin
u-boot-sd.bin
comx.dtb
uImage
rootfs-LRFS.tar.gz
rootfs-nfs.tar.gz
rootfs-dev.ext2.img
make: *** [release] Interrupt
[percy@localhost p2020]$ make release