Artesyn COMX-P2020 BSP User Guide (July 2014) - Manual (Page 25)

BSP Build Environment
COMX-P2020 BSP User Guide (6806800L84B) 25
make[1]: Leaving directory `/home/percy/p2020/linux/kernel'
[percy@localhost p2020]$
4.2.2 Configure the Linux Kernel
The COMX-P2020 can work well with default configuration. Also, the user can configure the
kernel with the command: "make kernel-config" at the P2020 BSP directory.
This step is not necessary to compile the Linux Kernel; it is just useful for the special
requirement on Linux Kernel. Also we strongly suggest to configure the Linux Kernel based on
the default COMX-P2020 configuration. (This means run "make config-default" before running
"make kernel-config").
[percy@localhost p2020]$ make kernel-config
…
.config - Linux Kernel v2.6.32 Configuration
qqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqq
lqqqqqqqqqqqqqqqqqqqqqqqqq Linux Kernel Configuration qqqqqqqqqqqqqqqqqqqqqqqqqqk
x Arrow keys navigate the menu. selects submenus --->. Highlighted x
x letters are hotkeys. Pressing includes, excludes, modularizes x
x features. Press to exit, for Help, for Search. Legend: x
x [*] built-in [ ] excluded module < > module capable x
x lqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqqk x
x x [ ] 64-bit kernel x x
x x Processor support ---> x x
x x General setup ---> x x
x x [*] Enable loadable module support ---> x x
x x [*] Enable the block layer ---> x x
x x Platform support ---> x x
x x Kernel options ---> x x
x x Bus options ---> x x
x x Advanced setup ---> x x
x x [*] Networking support ---> x x