Artesyn PrAMC-7311 Installation and Use (June 2014) - Manual (Page 115)

Basic Input Output System
PrAMC-7311 Installation and Use (6806800P34D) 115
Parity Check 1 nnnn Parity error found in system bus. BIOS
attempts to locate address nnnn and
display it on screen. If it cannot locate the
address, it displays?. Check for correct memory
module types.
Parity Check 2 nnnn Parity error found in system bus. BIOS
attempts to locate address nnnn and
display it on the screen. If it cannot locate
the address, it displays?. Check for correct memory
module types.
Press to resume, to
Setup Displayed after any recoverable error
message Press to start boot
process or to enter
setup and change any
settings.
Press to enter Setup Optional message displayed during POST.
Can be turned OFF in setup. None
Previous boot incomplete -
Default configuration used Previous POST did not complete
successfully. POST loads default values
and offers to run setup. If failure was
caused by incorrect values and they are
not corrected, the next boot is likely to
fail. Run setup to restore original
configuration. This error is
cleared the next time the
system is booted.
Real time clock error Real-time clock fails BIOS test May require blade repair
Run the I2O Configuration
Utility One or more unclaimed block storage
devices have the configuration request
bit set in the LCT. Run an I2O Configuration
utility.
Shadow RAM Failed at offset:
nnnn Shadow RAM failed at offset nnnn of the
64k block at which error was detected. Contact your local sales
representative or services for
further support.
nnnn Shadow RAM Passed nnnn is amount of shadow RAM in KBs
successfully tested None
Software NMI Failed ServerBIOS2 test error: Cannot generate
software NMI None
System battery is dead -
Replace and run SETUP The NVRAM (CMOS) clock battery
indicator shows the battery is dead Replace battery and run
Setup to reconfigure system.
System BIOS shadowed System BIOS copied to shadow RAM None
Table 6-33 Example BIOS Messages (continued)
Message Explanation Corrective Action