Artesyn PrAMC-7311 Installation and Use (June 2014) - Manual (Page 114)

Basic Input Output System
PrAMC-7311 Installation and Use (6806800P34D) 114
Extended RAM Failed at offset:
nnnn Extended memory not working or not
configured properly at offset nnnn Contact your local sales
representative or services for
further support.
nnnn Extended RAM Passed nnnn represents amount of RAM in MBs
successfully tested. None
Failing Bits: nnnn nnnn is a map of the bits at the RAM
address (in system, extended or shadow
memory) which failed the memory test.
Each 1 (one) in the map indicates a failed
bit. Contact your local sales
representative or services for
further support.
Fail-Safe Timer NMI Failed ServerBIOS2 test error: Fail-save timer
takes too long None
Incorrect Drive A type - run
SETUP
Incorrect Drive B type - run
SETUP Type of floppy drive not correctly
identified in setup Check for correct floppy
drive in setup.
I/O Device IRQ Conflict I/O device IRQ conflict error Resolve conflict in setup.
Keyboard controller error Keyboard controller failed test Replace keyboard
Keyboard error Keyboard not working Check for correct keyboard
connection.
Keyboard error nnn BIOS discovered a stuck key and displays
scan code nn for stuck key. Replace keyboard, check for
stuck keys.
Keyboard locked - Unlock key
switch Keyboard locked. Unlock the system to
proceed
Memory Size found by POST
different from CMOS Memory size found by POST is different
from the one stored in CMOS None
Monitor type does not match
CMOS - Run SETUP Monitor type not correctly identified in
setup None
Operating system not found Operating system cannot be located on
either drive A: or drive C:. Enter setup and check if fixed
disk and drive A: are properly
identified.
Table 6-33 Example BIOS Messages (continued)
Message Explanation Corrective Action