Artesyn PrAMC-7311 Installation and Use (June 2014) - Manual (Page 113)

Basic Input Output System
PrAMC-7311 Installation and Use (6806800P34D) 113
6.12 Updating the BIOS
For information on updating the BIOS on your PrAMC-7311, please refer to the Basic Blade
Services Software for your release, listed in
Appendix B, Related Documentation .
6.13 BIOS Messages
The following messages may be displayed, if for example, the system fails after making
changes in the setup menus.
If it is not possible to fix a problem with the help of this section, contact your local sales
representative or services for further support.
Save the changes Save the Changes done
Table 6-32 Exit Menu
Section Description
Table 6-33 Example BIOS Messages
Message Explanation Corrective Action
Allocation Error for Resource conflict for the specified device Run ISA or EISA configuration
utility to resolve conflict.
nnnn Cache SRAM Passed nnnn represents the amount of system
cache in KBs successfully tested None
CPU ID CPU socket number for multi-processor
error None
Diskette drive A error
Diskette drive B error Drive A: or B: fails the BIOS POST disk
tests. Drive is selected via setup but is
either not present or is defective Check the following:
The drive is defined with
proper disk type in setup
The disk drive is attached
correctly
The controller is enabled.
DMA Test Failed ServerBIOS2 test error: Cannot write to
extended DMA None
Entering SETUP... Starting setup program None