Artesyn PrAMC-7311 Installation and Use (June 2014) - Manual (Page 111)

Basic Input Output System
PrAMC-7311 Installation and Use (6806800P34D) 111
To Change a Device’s Priority
Follow these steps to change priorities of the boot device.
1. Select the device using the up or down arrow keys.
2. Use to include or exclude the boot devices.
3. Use the [+] or [-] keys to move the priority up or down.
4. Press to exit to the Exit Menu.
6.11 Exit Menu
Exit Saving Changes
Select [Exit Saving Changes] to store the selections displayed in the menus in CMOS.
CMOS is a special section of memory that remains intact even when the system is turned off.
On rebooting the computer, BIOS configures the system according to saved Setup selections
stored in CMOS. During boot-up BIOS attempts to load values saved in CMOS.
If values cause the system boot to fail, reboot and press to enter BIOS setup. Load setup
defaults or change selections that caused the boot to fail.