Artesyn COMX-P4080-2G-ENP2 Installation and Use (August 2014) - Manual (Page 65)

BSP
COMX-P4080-2G-ENP2 Installation and Use (6806800P63B) 65
7.4.1 Pre-deployment Steps
The following steps must be performed before deployment:
1. Connect the board to your network using a network cable to the SGMII Ethernet port.
2. Setup a TFTP server in this network. Assuming that the IP address of this server is
192.168.0.100 and the root directory is /tftpboot/.
3. Create a comx_p4080/ in /tftpboot/ subdirectory.
4. Copy the COMX_P4080_.tar.gz file into the directory /tftpboot/
comx_p4080/ on TFTP server.
5. Change current directory to /tftpboot/comx_p4080/.
6. Unzip the .tar.gz file to the current directory. The following files are extracted to the
COMX_P4080_V100B00/:
 comx.dtb
 rcw.bin
 rcw-codewarrior.bin
 rootfs_ext2.img
 rootfs_nfs.tar.gz
 uImage
 fsl_fman_ucode_P3_P4_P5_101_8.bin
 u-boot.bin
7. Unzip the rootfs_nfs.tar.gz file to the /tftpboot/comx_p4080/ location using
the sudo tar xzvf COMX_P4080_V100B00/rootfs_nfs.tar.gz.
8. Add /tftpboot/comx_p4080/rootfs_nfs/ to NFS exports list in /etc/exports:
/tftpboot/comx_p4080/rootfs_nfs *(rw,sync,no_root_squash).
9. Restart NFS service to export /tftpboot/comx_p4080/rootfs_nfs/ using the
sudo /sbin/service nfs restart
command.
10. The following commands should be executed in U-boot command line.
11. Setup the U-Boot environment variables for the network settings. Example:
=> setenv ethaddr 00:01:af:12:23:01