Artesyn COMX-P4080-2G-ENP2 Installation and Use (August 2014) - Manual (Page 20)

Introduction
COMX-P4080-2G-ENP2 Installation and Use (6806800P63B) 20
 4 UARTs or 2 DUARTs
 (P4080) 0/1/2 GE ports (option available to use this port as USB)
 (P4080) 5/4/0 USB ports
 1588 signals output to the COME connectors
 Total 3 I2C buses
 1 SPI bus with 3 chip select signals
 Connected from the SDHC pins to COME connectors
 Connected from the tamper detect pins to COME connectors
 8 GPI and 8 GPO to COME connectors
 On-board RTC and WDT device
 Provide both remote and local thermal sensor
 JTAG connector on module
 Aurora testing points on module
 On-board regulators supply required voltages to devices on the module
 12V and 5V standby power supplied to module from ATX-type (or other type) power
supply through COME connectors
1.2 Standard Compliances
This product meets the following standards:
Table 1-1 Standard Compliance
Standard Description
UL60950-1 EN 60950-1 IEC 60950-1
CAN/CSA C22.2 No 60950-1 Safety Requirements
CISPR 22 CISPR 24 EN55022 EN
55024 EMC Requirements on system level
ENTSI EN 300 019 Series Environmental Requirement