Artesyn COMX-P2020 Installation and Use (July 2014) - Manual (Page 38)

Hardware Preparation and Installation
COMX-P2020 COM Express Module Installation and Use (6806800K97D) 38
2.5 Installing and Removing the Memory Module
There is one 204-pin SOUDIMM slot on the COMX-P2020 COM Express Module.
Installing a Memory Module
1. Wear the ESD-preventive wrist strap.
2. Lay the COM-E module where the SOUDIMM is to be installed on the antistatic
desktop.
3. Take the SOUDIMM out of the antistatic package, holding it by the edges.
4. Line up the notch located on the row of the metal pins at the bottom of the module
with the key in the SOUDIMM slot on the COM-E module.
5. Insert the SOUDIMM in a slantwise position or at a 45-degree angle to slide the
memory module into place.
Pin Damage
Forcing the module into the system may damage connector pins.
If the module hangs during insertion, pull it out and insert it again.