Artesyn COMX-P1022 Installation and Use (July 2014) - Manual (Page 77)

Firmware Upgrade
COMX-P1022 COM Express Module Installation and Use (6806800M04C) 77
3. Power on the board. Normally, the following information can be seen at the
terminal of the host:
U-Boot 2009.11-V100R00 (Sep 05 2011 - 17:47:19)
CPU0: P1022E, Version: 1.1, (0x80ee0011)
Core: E500, Version: 5.1, (0x80211151)
Clock Configuration:
CPU0:1066.667 MHz, CPU1:1066.667 MHz,
CCB:533.333 MHz,
DDR:333.333 MHz (666.667 MT/s data rate) (Asynchronous), LBC:33.333
MHz
L1: D-cache 32 kB enabled
I-cache 32 kB enabled
Board: COMX-P1022
I2C: ready
SPI: ready
DRAM: Initializing.... 2 GB
FLASH: None
L2: 256 KB enabled
MMC: FSL_ESDHC: 0
EEPROM: NXID v0
EEPROM: COMX
PCIE1 connected to Slot 1 as Root Complex (base addr ffe0a000)
PCIE1 on bus 00 - 00
PCIE2 connected to Slot 3 as Root Complex (base addr ffe09000)
PCIE2 on bus 01 - 01
PCIE3 connected to Slot 2 as Root Complex (base addr ffe0b000)
PCIE3 on bus 02 - 02
In: serial
Out: serial
Err: serial
Net: eTSEC1, eTSEC2
RTC: M41ST85W@68
Hit any key to stop autoboot: 0
=>
4. Set the u-Boot environment variables for the network settings through the
terminal: