Artesyn Centellis 2000 User Card-10GE with Telco Alarm Installation and Use (May 2014) - Manual (Page 43)

Board Exchange
Centellis 2000 User Card 10GE with Telco Alarm Installation and Use (6806800M46B) 43
4.2.1.2 Power Requirements
Make sure that the board is used in Centellis 2000 AdvancedTCA shelf. If the module is used in
a Centellis 2000 DC version shelf, make sure it is connected to -48 VDC up to -60 VDC (rated
voltage), according to Telecommunication Network Voltage (TNV-2).
A TNV-2 circuit is a circuit whose normal operating voltages exceed the limits for a safety-extra-
low-voltage (SELV) under normal operating conditions, and which is not subject to over
voltages from telecommunication networks.
On board voltages are 5.0 VDC, 3.3 VDC, and 1.0 VDC:
 5.0 V voltage is generated from the -48 V AdvancedTCA power by a DC/DC converter with
galvanic isolation suitable for TNV-2 circuits.
 3.3 V and 1.0 V voltages are derived from the 5.0 V power.
Shock Half-sine, 11 mSec, 30 m/Sec 2 Blade level packaging
Half-sine, 6 mSec at 180 m/Sec
2
Free fall - 200 mm/all edges and corners
1.0 m (packaged) per ETSI 300 019-2-2
(Blade level packaging)
100 mm (unpackaged) per GR-63-CORE
Table 4-1 Environmental Requirements (continued)
Feature Operating Non-Operating (packed state)
Table 4-2 DC Board Power Requirements
Feature Value
Rated Voltage -48 VDC to -60 VDC
US and Canada: -48 VDC
Operating Voltage -39 VDC to -72 VDC
US and Canada: -39 VDC to -60 VDC
Input current Typical with SFP+ module 0.11 A, Maximum with SFP+
module 0.16 A
Centellis 2000 User Card 10GE with Telco
Alarm power dissipation Typical with SFP+ module 5.7 W, Maximum with SFP+
module 7.9 W, without SFP+ module substrate 1.0 W