Artesyn Centellis 2000 User Card-10GE with Telco Alarm Installation and Use (May 2014) - Manual (Page 27)

Centellis 2000 User Card 10GE Hardware
Centellis 2000 User Card 10GE with Telco Alarm Installation and Use (6806800M46B) 27
2.5 Installing and Removing SFP/ SFP+ Modules
This section describes how to install and remove SFP/SFP+ modules.
Table 2-1 provides the list of SFP/SFP+ modules tested to use with Centellis 2000 User Card.
Eye Damage
Optical SFP/SFP+ modules may emit laser radiation when no cable is connected.
Avoid staring into open apertures to avoid damage to your eyes.
Personal Injury and Damage of the RTM and SFP/SFP+ Modules
Installing and using SFP/SFP+ modules which are not fully certified and which do not meet
all relevant safety standards may damage the RTM and the SFP/SFP+ modules and may lead
to personal injury.
Only use and install SFP/SFP+ modules which are fully certified and which meet all relevant
safety standards.
Personal Injury
Optical SFP/SFP+ modules may be classified as laser products. When installing and using any
of these SFP/SFP+ modules, the regulations which correspond to the respective laser class
apply to the whole RTM. Not complying to these regulations, may lead to personal injury.
When installing and using optical SFP/SFP+ modules which are classified as laser products,
make sure to comply to the respective regulations.
SFP/SFP+ modules can be installed or removed while the RTM is powered and non-powered.
The presence and also the type of SFP/SFP+ modules is automatically detected.
Table 2-1 SFP/SFP+ Modules
Part Number Vendor
TRX10GVP2010EP01 Merge Optics