Instructions, Wall-mounting instructions, Desktop mounting instructions – ARRIS WBM750 User Guide User Manual
Page 15
Instructions
Wall-mounting instructions
Note:
When mounting the Wideband Cable Modem on drywall, try to position
the modem so at least one of the screws are fastened to a stud. This
may prevent the Wideband Cable Modem from pulling out of the wall in
the future.To prevent overheating, do not block the ventilation holes on
the sides of the unit.
1 Position the mounting template on the surface where you intend to mount
the Wideband Cable Modem and secure in place with transparent tape.
2 Drill holes through the template in the specified locations for the mounting
screws. After drilling holes, remove the template from the surface.
3 If using drywall anchors, set them into the wall. Then, drive the screws into
the wall leaving a gap of about 1/8” (3 mm) between the screw head and
the wall. If not using anchors, just drive the screws.
4 Orient the Wideband Cable Modem with the indicator lights facing up or
right, as desired. Slip both mounting slots (in the back of the Wideband
Cable Modem) over the screws, then slide the case down until the narrow
end of the keyhole slot contacts the screw shaft.
5 Proceed to
Connecting the Wideband Cable Modem
Desktop mounting instructions
1 Position the Wideband Cable Modem so that:
• air flows freely around it
• the back faces the nearest wall
• it will not fall to the floor if bumped or moved
2 Proceed to
Connecting the Wideband Cable Modem
Touchstone WBM750 Wideband Cable Modem User’s Guide
15
Step 1
Step 2
Step 3
Step 4