AMETEK HPD Series - Manual (Page 24)

Installation and Configuration
Remote/Local Operation
22 Operating Manual for GPIB for XT/HPD Series Power Supply
Table 2.4 Remote Mode Power On Conditions
LOC
Command
The LOC command overrides the Remote/Local switch. Use LOC to enable or
disable one or all slave supplies to operate in local mode. See “Command Reference”
on page 40.
Condition Default Settings 7.5-140 Model Example
Voltage 0 V VSET 0
Current 0 A ISET 0
Soft Voltage Limit VMAX (see models) VMAX 7.5
Soft Current Limit IMAX (see models) IMAX 140
OVP Trip Voltage Model VMAX + 10% OVSET 8.25
Delay 0.5 s DLY 0.5S
Foldback Protection OFF FOLD OFF
Output ON OUT ON
Hold OFF HOLD OFF
Unmask NONE UNMASK NONE
Service Request Capability OFF SRQ OFF
AUXA OFF AUXA OFF
AUXB OFF AUXB OFF