AMETEK HPD Series - Manual (Page 23)

Installation and Configuration
Remote/Local Operation
21
Remote/Local Operation
You can enable or disable remote or local operation of your power supply in one of
three ways:
• Rear panel Remote/Local switch SW1-1, or
• GPIB LOC command, or
• Local Mode Disable Jumper J95 selection.
Remote/Local
Switch
Use the rear panel Remote/Local switch SW1-1 to toggle between remote and local
operation without losing programmed values. To locate the switch, refer to the
“Power Supply Rear Panel with GPIB Interface Installed” on page 16.
Powering up in remote mode will result in the default operating conditions in
Table 2.4. See also “Command Reference” on page 40.
Rear Panel SW1-1 Position Operation Selected
Open Unit in remote mode
Closed Unit in local mode