Running the sample project – Zilog ZMOT0BHH User Manual
Page 20
UM023902-1013
16
ZMOTION
®
20-Pin Detection and Control Development Kit
User Manual
2. Attach the free end of the ribbon cable to the DBG connector (ZDI Interface) on the
development board. Ensure that pin 1 on the ribbon cable (indicated by the dark stripe)
is aligned with pin 1 on the target connector (indicated by a 1 on P2 of the board).
3. Install the FTDI USB-to-serial driver. For assistance, see
Running the Sample Project
In this example, we reference the
ZMOTION_Serial_Config
project, which is the proj-
ect that the kit is initially programmed with. The steps that follow show you how to build
the project and run it on the ZMOTION Module in a debug session; these steps also apply
to any of the other projects provided in the kit.
At this point, you should have installed the FTDI-to-USB Serial Driver and loaded ZDS II
and the USB SmartCable driver onto your computer. If you haven’t yet done so, refer to
Appendix A. Installing the USB SmartCable Driver
on page 23 and/or
Installing the FTDI USB-to-UART Driver
on page 26 to learn more about how to install
these items.
1. Open ZDS II and select
File
→
Open Project
, then navigate via the following path to
the project folder labeled
ZMOTION_Serial_Config
:
C:\Program Files\Zilog\ZMOTIONL200ZCOG_
Downloads\ZMOTION_Serial_Config
2. Open the
ZMotion_Serial_Config_20_Pin.zdsproj
project. When you first re-
ceive your kit, this project is already loaded into the ZMOTION MCU. Right-click
within the open grey area below the menu icons and select
Workbook Mode
to turn on
the tabs at the bottom of the editor and therefore make it easier to switch between files.
3. Click the
Rebuild All
icon to build the project. The build output should not indicate any
errors. If you receive errors, try reloading the projects from the original Application CD
and ensure that the folders are not set to
Read Only
. See Figure 12 for an example; Fig-
ure 13 indicates the location of the
Rebuild All
icon in the ZDS II menu bar.
Note: