Zilog ZMOT0BHH - Manual (Page 15)

UM023902-1013 11
ZMOTION ® 20-Pin Detection and Control Development Kit
User Manual
To assemble the lens and lens holder, observe the following brief procedure.
1. Place the circular lens into the base of the lens holder, aligning the notch on the lens
with the inside notch on the base.
2. Place the circular cap over the lens and the base ensuring the outside tab on the cap
aligns with the outside tab on the base. Use the provided ¾" machine screws (2) with a
nut to secure the cap in place.
3. Place the lens and lens holder assembly onto the ZMOTION 20-Pin Development
Board by aligning the screw holes on the lens holder with the upper set of holes on the
circuit board, as shown in Figure 6. The 4 screw holes in the circuit board should line
up with the four center-mounting holes in the lens holder.
Figure 5. Circular 0.77" Lens Holder (Cap and Base)