Xtramus NuApps-POE V1.0 - Manual (Page 31)

27
E-Mail: [email protected]
Http://www. X tramus.com
XTRAMUS TECHNOLOGIES®
Check the Visible box for the power measurements of Voltage and/or Current to show
the information in chart.
Cursor 1- Refers to the value at the Cursor 1 position. Click on any point on chart with
the mouse and Shift button at the same time to move the cursor and to change the
value.
Cursor 2- Refers to the value at the Cursor 2 position. Click on any point on chart with
the mouse and Ctrl button at the same time to move the cursor and to change the
value.
Delta- Refers to the difference of the values between Cursor 1 and Cursor 2.
Delta Time (ms)- Refers to the time difference between Cursor 1 and Cursor 2.
On the right side of the chart, Report shows different power measurements of the
results for different tests.
For Connect Test, there are Iclass (mA), T pdc (ms) and Power Status (Power
Good/No Power).
To title the chart, input a title in a pane under Set Chart Title, then press Set button to
Initial chart title