WaveWare Call Manager - Manual (Page 27)

STEP 9 – Register Call Devices – Wireless Inovonics
Configuring the “Inovonics Wireless System Input Port”
Configured for use as a Universal Transmitter - “ Terminal ” Device (Ex: Contact Closure)
Choose the “ Inovonics EN Wireless System Input Port ”. See Fig. 40-2 “ B ”
To “ Register Call Devices ” simply “ Trigger ” the Device and wait until you see it on the Screen. See Fig. 40-2 “ A ”
NOTE: Trigger one Device at a time and wait a Few Moments until the System “Acknowledges” the Device.
Fig. 40-2
In this Example the Device is being used with a Contact Medical Device.
This model Universal Transmitter only has a “Terminal” Block, so when the
Device is Triggered and Reset, the Device will send out a Signal to the Central
Receiver which is attached to the Call Manager Software. The Call Manager
Software sends an Alert Message out to the Assigned Msg Recipient (Pager).
Fig. A:
Trigger the Wireless Call
Device and wait a Few
Moments.
The New Device should be
Displayed on the Screen.
After the Device is Shown, you
can Choose:
-The “Device Type”
-The “Room”
Do this for Every Device Type
Registered.
Note: You can Assign the
Room at a Later time, if you
wish.
Fig. B:
Choose One:
-Call System Input Port
-Inovonics EN Wireless System
Input Port
Here in this Example we are
Working with the
Inovonics
Wireless System Input Port to
Register Wireless Call Devices.
Fig. C:
Choose Call Processing:
In this Example the Universal
Transmitter is used as a
Contact Closure .
For this Purpose the
Call
Processing should be set to
“ Terminal ” for Both Initiation
and Cancelation.
You can also Assign an
“
Installer ” Pager, to be used for
Testing during this Time.
27