WaveWare Call Manager - Manual (Page 25)

STEP 9 – Register Call Devices – Wired Call Systems
Configuring the “Wired Call System Input Port”
Configuration for use as a Wired Call Device - “ Contact Closure ” Device
Choose the “ Wired System Input Port ”. See Fig. 39-1 “ B ”
To “ Register Call Devices ” simply “ Trigger ” the Device and wait until you see it on the Screen. See Fig. 39-1 “ A ”
NOTE: Trigger one Device at a time and wait a Few Moments until the System “Acknowledges” the Device.
Fig. 39-1
In this Example the Device is being used with a Contact Medical Device.
When the Resident Pushes the Call Button on the Call Cord, the Device is
Triggered and will send out a Signal to the Call Manager Software which sends a
Alert Message out to the Assigned Recipient (Pager or Email Address).
Fig. A:
Trigger the Wired Call
Device and wait a Few
Moments.
The New Device should be
Displayed on the Screen.
After the Device is Shown,
you can Choose:
-The “Device Type”
-The “Room”
Do this for Every Device
Type Registered.
Note: You can Assign the
Room at a Later time, if you
wish.
Fig. B:
Choose One:
-Call System Input Port
-Inovonics EN Wireless
System Input Port
Here in this Example we are
Working with the
Call
System Input Port to
Register Wired Call Devices.
This Device Type is a
Call
Cord , which Normally works
with a Contact Device .
You can also Assign an
“
Installer ” Pager, to be used
for Testing during this Time.
25