Vectronics VEC-1120K - Manual (Page 4)

VEC-1120K/1130K/1140K/1180K Instruction Manual
2
BEFORE YOU START BUILDING:
Experience shows there are four common mistakes builders make. Avoid these,
and your kit will probably work on the first try! Here's what they are:
1. Installing the Wrong Part: It always pays to double-check each step. A
1K and a 10K resistor may look almost the same, but they may act very
differently in an electronic circuit! Same for capacitors--a device marked
102 (or .001 uF) may have very different operating characteristics from one
marked 103 (or .01uF).
2. Installing Parts Backwards: Always check the polarity of electrolytic
capacitors to make sure the positive (+) lead goes in the (+) hole on the
circuit board. Transistors have a flat side or emitter tab to help you identify
the correct mounting position. ICs have a notch or dot at one end indicating
the correct direction of insertion. Diodes have a banded end indicating
correct polarity. Always double-check--especially before applying power to
the circuit!
3. Faulty Solder Connections: Inspect for cold solder joints and solder
bridges. Cold solder joints happen when you don't fully heat the connection--
or when metallic corrosion and oxide contaminate a component lead or pad.
Solder bridges form when a trail of excess solder shorts pads or tracks
together (see Soldering Tips below).
4. Omitting or Misreading a Part: This is easier to do than you might think!
Always double-check to make sure you completed each step in an assembly
sequence.
Soldering Tips:
Cleanliness and good heat distribution are the two secrets of professional
soldering. Before you install and solder each part, inspect leads or pins for
oxidation. If the metal surface is dull, sand with fine emery paper until shiny.
Also, clean the oxidation and excess solder from the soldering iron tip to ensure
maximum heat transfer. Also, clean the oxidation and excess solder from the
soldering iron tip to ensure maximum heat transfer. Allow the tip of your iron to
contact both the lead and pad for about one second (count "one-thousand-one")
before feeding solder to the connection. Surfaces must become hot enough for
solder to flow smoothly. Feed solder to the opposite side of the lead from your
iron tip--solder will wick around the lead toward the tip, wetting all exposed
surfaces. Apply solder sparingly, and do not touch solder directly to the hot iron
tip to promote rapid melting.
Desoldering Tips: