Vectronics VEC-1120K - Manual (Page 3)

VEC-1120K/1130K/1140K/1180K Instruction Manual
1
INTRODUCTION
Whether you’re a novice or seasoned “pro”, you’ll be pleasantly surprised at
how these receivers perform! SSB, CW and AM signals from hams around the
world are easily copied; their sensitivity rivals those receivers that cost many
times more. Build the receiver for your favorite band. Eight tuning options
allow you to customize the tuning range from full-band to 100-kHz or less. Use
it on-the-go or at home with your home-brew or Vectronics QRP CW transmitter
kit. Powered by a common 9-volt transistor battery, it’s always ready for action
on Field Day or camping trips!
TOOLS AND SUPPLIES
Construction Area: Kit construction requires a clean, smooth, and well-lighted
area where you can easily organize and handle small parts without losing them.
An inexpensive sheet of white poster board makes an excellent construction
surface and provides protection for the underlying table or desk. Well-diffused
overhead lighting is a plus, and a supplemental high-intensity desk lamp is
especially helpful for close-up work. Safety is always important! Be sure to use
a suitable high-temperature stand for your soldering iron, and keep the work area
free of combustible clutter.
Universal Kit-building Tools: Although your particular kit may require
additional items for completion, virtually all construction projects require a work
area outfitted with the following tools and supplies:
! 30 to 60 Watt Soldering Iron (grounded-tip and temperature-controlled
preferred)
! High-temperature Iron Holder with Cleaning Sponge
! Rosin-core Solder (thin wire size preferred, .031”)
! Needle Nose Pliers or Surgical Hemostats
! Diagonal Cutters or “Nippy Cutters”
! Solder Sucker (squeeze or vacuum pump type), or Desoldering Braid
! Bright Desk Lamp
! Magnifying
Glass
Special Tools for This Kit:
! "Hex” tuning tool
! “Blade” type tuning tool or jeweler’s screwdriver