Dynalink RTA1320 - Manual (Page 7)

6
ADSL 2+ Modem Router Quick Set-up Guide
If previously the computer had a modem for Internet connection, check your
browser setting. The system may still try to communicate through the previous
connection. In Internet Explorer, go to
Tools–Internet options–Connections,
select Never dial a connection. Close Internet Explorer to take effect.
PPPoE
Caution - Only follow this section if your ISP advises explicitly the service is
PPPoE. If you have followed the procedure below by mistake, reset router to
factory default will restore router to the standard New Zealand setting.
From the Quick Start menu click on Quick Setup to configure for PPPoE.
1. Untick the Auto Scan Internet Connection box. VPI and VCI shall be set to 0
and 100 respectively. Click Next for the next page.
2. Select PPP over Ethernet (PPPoE). Encapsulation shall be LLC/SNAP as
illustrated below. Go to the next page, change nothing and then Next.
3. You can enter your Internet account User Name & Password now. If you leave
the space as blank, you will be asked to do it later. Go Next.
4. Do not change the network configuration unless you are an advanced user
having your own preferences. Go Next.
5. A summary of the configuration is displayed. Check carefully that the setting
is VPI/VCI = 0/100, Connection Type is PPPoE LLC/SNAP. Then click Finish
to confirm the changes. The router will restart itself automatically to activate
the new setting.