Dynalink RTA1320 - Manual (Page 11)

ADSL 2+ Modem Router Quick Set-up Guide
of your router and network. Use the built in access control list to restrict
access to only authorised Internet hosts.
Enable IP extension (bridging) without firewall protection. If the router operating
in this mode is connected to a computer, to the minimum have a “personal
firewall” (software) to protect the computer.
Send your router away for repair or replacement without resetting to factory
default or wiping out your Internet account login details. Use the Backup
Configuration option to store your router’s setting elsewhere. This function
can be found in the router’s
Management > Backup Config menu. When a
replacement unit is received, restore the original setting from the backup file.
Indicator lights
There are 5 indicators on the front panel.
9
Function Colour & Status Definition
Off Power is off.
Solid Green Power is on and the device operates normally.
Solid Red Power on self-test in progress.
The device enters the console mode of
the boot loader.
Power on self-test failure if this light
remains solid.
Flash Red Firmware upgrade in progress
Off No DSL signal is detected
Slow Flash Green DSL line handshaking in progress
Fast Flash Green DSL line training in progress
Solid Green DSL line connected
Off Modem is not online
Solid Green Modem is online
Off No Ethernet signal is detected
Flash Green Data going through Ethernet port
Solid Green Ethernet interface is ready
Off No USB signal is detected
Flash Green Data going through USB port
Solid Green USB interface is ready
Power
DSL
PPP
Ethernet
USB