Dynalink RTA1320 - Manual (Page 3)

Default Configuration for New Zealand
This Router is shipped with the following factory default settings.
Router IP address 192.168.1.1
Subnet mask 255.255.255.0
VPI 0
VCI 100
Connect mode PPPoA VC-MUX
NAT enabled
DSL line mode G.DMT
WAN IP dynamic
DHCP enabled
DNS relay
on
UPnP IGD enabled
Firewall:
Incoming requests
blocked
Outgoing traffic not blocked
Router configuration & management:
User name
admin
Password admin
Telnet password admin
The majority of users in New Zealand will be able to connect using the default
factory setting. They can skip Section 6 of this Guide.
Only if your ISP advises
explicitly that you have a ”PPPoE service”, then you need to follow Section 6.
Before you start
Make sure your computer has these installed:
Ethernet or USB port
TCP/IP protocol enabled
A web browser, Internet Explorer 5.x/Firefox1.x/Netscape 6 or better.
Obtain your Internet account information from your ISP:
Login user name and password
Public IP address (only if you subscribe for static IP)
DNS server IP (only if specified by ISP).
1
2
ADSL 2+ Modem Router Quick Set-up Guide