Dynalink RTA1320 - Manual (Page 5)

OPTION 1 CONFIGURE COMPUTER TO GET IP ADDRESS
If your computer is already configured to obtain an IP address automatically (from
a DHCP server), do nothing. By default the router is a DHCP server and will assign
an IP to the computer automatically. Now go to
Section 5 – Getting On-Line.
OPTION 2 MANUALLY ASSIGN IP ADDRESS TO COMPUTER
The router’s default address is 192.168.1.1. If you prefer to assign an IP address
manually, the default can be changed from the router’s
Advanced > Local Network
> IP Address menu.
If you are unsure of your computer’s network setting, refer to Chapter 2 – System
Requirement & Installation of the User’s Manual. Pages 19-28 contain information
on
Setting TCP/IP for different versions of Windows. If you choose to follow
option (1) above, consult the section Configure PC to get IP address from DHCP
on pages 29-33.
After configuring your computer, go to Section 5 – Getting On-line.
Getting On-line
Before you start, the DSL & Ethernet (USB if you connect via USB) lights on the
router must be on. Refer to Section 10 – Troubleshooting of this Guide to resolve
any issues.
STEP 1 GO TO THE ‘CONNECT TO INTERNET’ PAGE
Start your web browser. Enter the default address http://192.168.1.1. Type
admin for both User name and Password.
See Q1 in Section 10 - Troubleshooting
if you cannot get this screen.
Next you will be in the Quick Start >
Connect to Internet page.
If your ISP specifies that your ADSL
service is PPPoE, you must now follow
Section 6 to change connect mode to
PPPoE. Check with your ISP if you are
unsure.
ADSL 2+ Modem Router Quick Set-up Guide
5