Thrustmaster Ferrari F1 RS - Manual (Page 480)

17/22
- Install the MOD fully and tightly into the bottom of the “Metal Stop” cavity.
- For strong resistance: position the MOD against the Upper wall.
- For even stronger resistance: position the MOD against the Lower wall.
Position against the Upper wall
(Resistance of around 14Kg/30.8lbs)
Position against the Lower wall
(Resistance of around 16Kg/35.2lbs)
- Once you have done so, tighten the “Metal Stop” (23) at the rear of the pedal arm
Position against the Upper wall Position against the Lower wall
(Resistance of around 14Kg/30.8lbs) (Resistance of around 16Kg/35.2lbs)
Important note:
To avoid any calibration problems, the “Realistic Brake” MOD must only be
installed in “Long Run” position
(do not install it in “Medium Run” or “Short Run” position)