Thor 4 Ch HD Analog or Digital to HDTV modulator - Manual (Page 12)

4-ADHD
9
3.1 Initial Status
After powering on the device，it will take a few seconds to initialize the system
 DVB-C: to indicate the modulation standard of this device.
 A/B/C/D: to indicate the 4 carrier outputs
 XXX.XX MHz: to indicate the current output frequency (Range: 30~999MHz) of the 4 carriers
output, which shows in turn.
 X.XX Mbps: to indicate the encoding bit rate of each encoding board respectively.
3.2 General setting for Main Menu
By pressing “Lock” key on the front panel, enter the main menu. The LCD will display the following
pages:
Press UP/DOWN buttons to specify menu items, and then press ENTER to enter the submenus as
below:
1) Status
Press Enter to enter “Status” and it displays the working time duration of the device
2) Input Sets
Under this submenu, the LCD will show “2.1 Input 1”, “2.2 Input 2” and “2.3 Input 3”.
Start up…
Start OK…
DVB-C A XXX.00MHz
P1 X.XXMbps P2 X.XXMbps
1 Status
2 Input Sets 3 Modulator
4 TS Config
5 Network
6 System
1.1 Uptime Uptime
2 Days-10:30:20
2 Days-10:30:20
2.1 Input 1
2.2 Input 2 2.3 Input 3