TEKVOX MMX88 Matrix Switcher - Manual (Page 26)

Modular Matrix Switcher 8x8 (with Audio)
21
No. Detailed Information
1 1080p 2D 5.1CH
2 1080p 2D 2.0CH
3 720p 2D 5.1CH
4 720p 2D 2.0CH
5 4kx2k 2D 5.1CH
6 4kx2k 2D 2.0CH
Update in-built EDID data by sending command UpgradeIntEDID[x]..
Examples:
1
、 Transfer signals from an input channel to all output channels: [x]All.
Example: Send
“3All.” to transfer signals from the input 3 to all output channels.
2
、 Transfer all input signals to corresponding output channels respectively:
All#.
Example: If this command is carried out, the status of matrix will be: 1->1, 2->2, 3->3,
4-
>4…… 8->8.
3
、 Switch off all the output channels: All$.
Example: After running this command, there will be no signals on all the outputs.
4
、 Switch off the detail feedback command from the COM port: /:MessageOff;
But, it will leave the “switch OK” as the feedback, when you switch the matrix.
5
、 Switch on the detail feedback command from the COM port: /:MessageOn;
It will show the detail switch information when it switch. Example: when switch 1->2, it
will feedback “AV01 to 02”.
6
、 Transfer signals from an input channel to corresponding output channel:
[x]#.
Example: “5#.” to transfer signals from the input5 to the output5.
7
、Switch off an output channel: [x]$.
Example:
“5$.” to switch off the output 5.
8
、Switch signal: [x1] B[x2].
Example: “1B2,3,5.” to transfer signal from the input1 to the output No. 2,3,5.
9
、Inquire the input channel to the output channel [x]: Status[x].
Example: Send
“Status2.” to inquire the input channel to the output 2.
10
、Inquire the input channel to the output channels one by one: Status.
Example: “Status.” to inquire the input channel to the output channels one by one.
11
、Save the present operation to the preset command [Y]: Save[Y].
Example: “Save7.” to save the present operation to the preset command No.7.