TEKVOX MMX88 Matrix Switcher - Manual (Page 21)

Modular Matrix Switcher 8x8 (with Audio)
16
No. Function
1 N/u Unused
2 Tx Transmit
3 Rx Receive
4 N/u Unused
5 Gnd Ground
6 N/u Unused
7 N/u Unused
8 N/u Unused
9 N/u Unused
When the Modular Matrix Switcher 8x8 (with Audio) connects to the RS232 port of a
computer with control software, users can control it with that computer. To control the
switcher, users need to use RS232 control software.
4.3.2. TCP/IP and RS232 Communication Commands
The following is a list of all of the commands used to remotely control the Modular
Matrix Switcher using either TCP/IP or RS232.
RS232 Communication protocol: Baud rate: 9600; Data bit: 8; Stop bit: 1; Parity
bit: none.
Type Command Description
Com
m
a
nd
s
fo
r M
a
in
Uni
t
/*Type; Inquire the models information.
/%Lock;
Lock the keyboard of the control panel on the
Matrix.
/%Unlock;
Unlock the keyboard of the control panel on the
Matrix.
/^Version; Inquire the version of firmware
/:MessageOff;
Turn off the feedback command from the com
port. It will only show the “switcher OK”.
/:MessageOn;
Turn on the feedback command from the com
port.
Undo. To cancel the previous operation.
Demo.
Switch to the “demo” mode, 1->1, 2->2, 3->3 …
and so on.
[x]All.
Transfer signals from the input channel [x] to all
output channels
All#.
Transfer all input signals to the corresponding
output channels respectively.
All$. Switch off all the output channels.
[x]#.
Transfer signals from the input channel [x] to the
output channel [x].
[x]$. Switch off the output channel [x].