Desa CB36N - Manual (Page 22)

www.desatech.com 117437-01D
OPERATING FIREPLACE
Continued
OF
F PIL
O
T
LO
IH
ON OFF REMOTE
ON
OFF
O N
Blower.Control.Knob.
(Optional.Accessory)
Variable.
Control.Knob
Selector.Switch.in.
Remote.Position
Gas.Control.Knob.
in.ON.Position
Figure 36 - Setting the Selector Switch,
Gas Control Knob and Variable Control
Knob for Remote Operation
. IMPORTANT:.Be.sure.to.press.the.ON/
OFF.buttons.on.hand-held.remote.control.
unit.for.up.to.3.seconds.to.assure.proper.
operation.
.. Press.ON/OFF.button.to.turn.the.burner.
on.and.off.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must
be purchased separately (see Accessories,
page 31). Follow instructions included with
the remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions, page 21.
After lighting, let pilot flame burn for about
one.minute..Turn.control.knob.to.ON.position..
Adjust flame adjustment knob anywhere be-
tween.HI.and.LO..Slide.the.selector.switch.to.
the.REMOTE.position.(see.Figure.36).
Note: Burner may light if hand-held remote
was on when selector switch was last turned
off. You can now turn burner on and off with
hand-held remote control unit.
IMPORTANT:.Do.not.leave.selector.switch.in.
the.REMOTE.or.ON.position.when.pilot.is.not.
lit..This.will.drain.battery.
Figure 37 - On/Off Hand-Held Remote
Control Unit HRC100
Control.
Button
Indicator.
Light
ON/OFF SERIES MODEL HRC100
Hold.control.button.on.hand-held.remote.until.
burner.turns.on..Hold.control.button.again.until.
burner.turns.off.(see.Figure.37).
TO.LOCK . press.both.buttons.on.hand-held.
remote control until light stops flashing. Hand-
held remote control is now locked. If fire is on
it. will. be. turned. off. automatically.. In. locked.
state, light will not light up when any button
is.pressed.
TO UNLOCk
. press. both. buttons. together.
on. hand-held. remote. control. until. light.
stops. flashing.. Hand-held. remote. is. now.
unlocked.
OPTIONAL GWMS2
ON/OFF WALL
MOUNTED SWITCH
WARNING: Do not connect
the appliance gas controls to a
120 VAC power source. Damage
or injury may occur.
Light. fireplace. as. instructed. in. Lighting
Instructions. on. page. 1. .. If. using. an. HRC.
remote with a wall switch, set remote selec-
tor.switch.to.the.ON.position.(see.Figure.36)..
Wall.switch.may.now.be.used.to.turn.burner.
flame ON and OFF.
To turn fireplace off, turn wall switch and/or
remote. selector. switch. to. the. OFF. position.
and.turn.gas.control.knob.back.to.PILOT..Pilot.
will.remain.lit.
IMPORTANT: To turn pilot off, turn gas control
knob.on.heater.to.the.OFF.position.