Desa CB36N - Manual (Page 19)

www.desatech.com 117437-01D 19
INSTALLING LOGS AND GLOWING
EMBERS
A.4.piece.ceramic.log.set.comes.packed.in-
side the unit firebox. Removal of glass door is
necessary.to.unpack.and.assemble.logs.and.
add. hearth. treatments.. Follow. steps. under.
Removing/Replacing Glass Door, page 18 to
access.logs.and.burner.
Assemble. logs. and. add. burner. treatments.
as.follows:
1.. Position.base.log.onto.burner.log.mounts.
(see.Figure.31).
Figure 31 - Installing Logs
FIREPLACE INSTALLATION
Continued
Figure 32 - Applying Ember Material
. Note: Cut out on bottom should fit over
mounts and base log should be positioned
against rear panel.
.. Position.holes.on.bottom.of.rear.log.over.
pins.on.base.log.(see.Figure.31).
3.. Position. top. left. log. and. top. right. log.
onto.rear.log.and.base.log.as.shown.in.
Figure.31.
4. Break ember material into quarter sized
pieces.and.place.a.single.layer.along.the.
full. length. of. ember. tray. to. hide. bottom.
edge.of.base.log.(see.Figure.3).
5.. Replace. glass. door. and. louver. panels.
(see. Removing/Replacing Glass Door,
page.18).
WARNING: The glass door
must be securely in place before
running this fireplace. Do not run
this fireplace if glass is missing
or broken.
Top.
Right.
Log
Top.Left.
Log
Rear.
Log
Burner.
Base.Log
Rear.Log.
Stand
Burner.
Pan
Log.
Mounts
Ember.
Tray
Ember.
Material