Desa CB36N - Manual (Page 13)

www.desatech.com 117437-01D 13
4.. Connect.one.wire.from.receiver.to.male.
connector.on.high.limit.harness.and.one.
to “TH” on control valve (see Figure 14,
page.1).
5.. Locate.two.plastic.mounting.clips.provided.
with.kit.
6. Use clips to mount receiver on remote
mounting.bracket.as.shown.in.Figure.16.
Installing 9-Volt Alkaline Battery in Hand-
Held Remote Control Unit
1.. Remove.battery.cover.on.back.of.remote.
control.unit.
.. Attach.terminal.wires.to.a.9-volt.alkaline.
battery.(not.included)..Place.battery.into.
battery.housing.(see.Figure.17).
3.. Replace.battery.cover.onto.remote.con-
trol.unit.
INSTALLING OPTIONAL CONTROLS
Continued
9-Volt.
Battery
Battery.
Housing
Battery.
Cover
Terminal.
Wires
Remote.
Control.
Unit
Towards Front
REMOTE ON OFF
Figure 16 - Mounting Remote Receiver to
Bracket
Figure 17 - Installing Battery in Hand-
Held Control Unit (HRC100 Series)
Figure 18 - Installing WRC Remote Receiver
Figure 19 - Installing Battery into Back of
Handset
Fireplace.
Receptacle Remote.
Control.
Receiver
Extension.Cord
Ignition.
Module.
Plug
Pull.to.
Remove.
Insulation.
Tab
Battery.Cover
1.Volt.Battery Back.of.Handset
Plastic.Mounting.
Clips
Remote.Receiver
INSTALLING OPTIONAL WIRELESS
REMOTE CONTROL - MODEL WRC
(Electronic Ignition)
Installing and Activating the Remote
Receiver
1.. Open.bottom.louver.and.locate.plug.re-
ceptacle..Plug.receptacle.is.located.either.
on.right.or.left.side.of.cabinet.
.. The.WRC.model.receiver.does.not.require.
a. battery.. Receiver. can. be. installed. by.
first plugging short extension cord into
fireplace receptacle. Then plug receiver
unit.into.extension.cord..Finally.plug.igni-
tion. module. plug. into. receiver. unit. (see.
Figure.18).
3.. Activate. remote. handset. battery. by. re-
moving.insulating.tab.on.back.of.handset.
(see.Figure.19)..Battery.is.included.pre-
installed.
4.. Once.battery.is.activated.unit.is.ready.to.
use.
5.. Replace.bottom.louver.panel.