Desa CB36N - Manual (Page 18)

www.desatech.com 117437-01D 18
Figure 28 - Removing Louver Panel
Louver.
Panel
Spring.
Latch
Removing/Replacing Glass Door
WARNING: Handle glass
door panel with care. Do not
strike, slam or otherwise abuse
glass. Do not operate fire-
place with glass door removed,
cracked or broken.
If replacement of glass is necessary, the
entire assembly, glass and frame, must be
replaced. If glass is broken, wear gloves and
tape.remaining.fragments.onto.frame.
1. Placing a screw driver or your finger tips
into. gap. between. lower. glass. panel. rail.
and bottom face frame, lift glass door as-
sembly.until.door.pins.clear.locating.holes.
in.bottom.face.frame.(see.Figure.9).
.. Swing.bottom.glass.panel.assembly.out.
until.door.pins.on.lower.rail.clear.bottom.
face.frame.(see.Figure.30).
3.. Lower.door.down.until.upper.door.pins.are.
free.of.locating.holes.in.spring.clips.and.
place.in.a.safe.area.
4.. Replace.glass.panel.in.reverse.order.by.
inserting top door pins into spring clips,
lifting.up.at.lower.frame.rail.and.locating.
bottom.pins.in.holes.on.lower.face.frame.
FIREPLACE INSTALLATION
Continued
Figure 30 - Removing/Replacing Glass
Door
Spring Clips
Glass Panel
Frame Rail
1. Lift Up Panel
at Lower Rail
Figure 29 - Removing/Replacing Glass
Door
Locating
Hole
Door Pin
Glass Panel
Frame Rail
2. Swing Out
Panel
3. Lower
Panel Out
Removing Louver Panels
Remove. top. and. bottom. louver. panels. by.
simultaneously. pulling. both. top. end. spring.
latches.toward.center.of.appliance.until.they.
are. disengaged. from. locating. holes. (see.
Figure.8)..Repeat.for.bottom.spring.latches.
and.pull.louvers.outward..To.install.or.replace.
items removed, simply reverse procedures
above.