Signamax 100BaseTX To 100BaseFX Converters - Manual (Page 17)

Signamax 065-1100NS/1110NS/1120NS Series
100BaseTX/FX Media Converter
Installation 11
Desktop Installation
Follow the instructions listed below to install the Converter
onto a desktop location.
1. Locate the Converter in a clean, flat and safe position
that has easy access to AC power.
2. Affix the four (4) self-adhesive rubber pads to the
underside of the Converter
3. Apply AC power to the Converter. (The green PWR
LED on the front panel should light)
4. Connect cables from the network partner devices to the
ports on the front panel. (The green LNK LED on the
front panel associated with the port should light)
This Converter can also be mounted on a vertical surface.
Simply use the underside of the unit as a template to
measure and mark out the position of the holes on to the
surface where the unit is to be installed. Then use the two
screws provided to mount the Converter firmly in place.
Warning Please exercise caution when using power
tools. Also, install this unit away from damp or wet
locations, or in close proximity to very hot surfaces. These
types of environments can have a detrimental effect on the
converter and cables. An ideal location is a lightly cooled
place such as a typical equipment room.
Connecting To Power
The Converter uses an external power supply rated at 12V
DC @ 0.8A 50~60 Hz.
1. Insert the power cable plug directly into the receptacle
located at the back of the device.
2. Plug the power adapter into an available socket.