Operating procedures (4” display), 4” display illustration – Pengo TruLink User Manual
Page 19

PENGO TruLink Manual 19
OPERATING PROCEDURES (4” DISPLAY)
1. Ensure Display unit has power. Power is supplied by the auxiliary port located inside the prime movers cab.
2. Chose a convenient location to mount the TruLink display. The location should not interfere with safety devices (lap
bar) or compromise the operators visibility. The location should also allow the operator to easily access the display to
start and stop the data recording function.
2-A. The display can be mounted to a glass surface using the suction cup mount provided. When using the suction
cups be sure the surface is clean to allow for maximum adhesion against the glass.
2-B. The display can also be hard mounted to any surface using hardware (not included). This method is only
recommended if the location is to be permanent.
WARNING
Before operating, always ensure that all electrical connections are tight and free from potential hazards
and or entanglement during operation.
4” DISPLAY ILLUSTRATION
All interface with the 4” Display is done on the
touch screen. There are no external buttons.
Mounting Platform
Communication Port
Unscrew the port cover to access the USB port.
Back
Left
Right
Up
Down
Select
The selection buttons shown above will be used to
navigate and select functions on the screen.