Pengo TruLink - Manual (Page 10)

10 PENGO TruLink Manual
ANCHOR DRIVE TRULINK PIN INSTALLATION
Position the Anchor Drive in a manner
in which it will be safe to work on during
the pin installation. Remove the existing
connection pin.
1
Install the Anti-Rotation Block to the
Anchor Drive. The Anti-Rotation Block is
designed to fi t all Pengo Anchor Drives up
to the RT/DV 40 series.
Use the illustrations shown on the right to identify
the correct set-up instructions for your specifi c
Pengo Anchor Drive.
2
NOTE: Do NOT use a hammer or any other object at any time during the installation of
the TruLink pin. Hitting the head of the pin with a object will damage the CPU processor
and will VOID the warranty.
Use of the Anti-Rotation Block is NOT optional.
It must be used in order for the torque and
inclinometer values to be accurate!
Figure 2A
RS-12, RT-9 & RT-12 Installation.
Use this set of holes for
adjustment screws.
Figure 1A
DS-3 & RS-7 Installation.
Spacer Bar used on
DS-3 & RS-7 Only.
Use this set
of holes for
adjustment
screws.
Figure 3A
RT-20, RT-30 & RT-40 Installation.
Use this set of holes for
adjustment screws.
DS-3 & RS-7 Requires:
PART No. QTY DESCRIPTION
615006 1 ANTI-ROTATION BLOCK
610610 2 SCREW SOCHD M10 X 60mm
615029 1 SPACER CLASS 1
610298 2 NUT HEX LOCK M10
610663 2 SET SCREW 5/16” X 1”
610664 2 JAM NUT 5/16”
DT-5, RS-12, RT-9 & RT-12 Requires:
PART No. QTY DESCRIPTION
615006 1 ANTI-ROTATION BLOCK
610610 2 SCREW SOCHD M10 X 60mm
610298 2 NUT HEX LOCK M10
174526 2 BOLT HEX 5/16” X 2-1/4”
610664 2 JAM NUT 5/16”
RT-20, RT-30 & RT-40 Requires:
PART No. QTY DESCRIPTION
615006 1 ANTI-ROTATION BLOCK
700534 2 LOCK WASHER 10mm
670175 2 SCREW SOCHD M10 X 40mm
174526 2 BOLT HEX 5/16” X 2-1/4”
610664 2 JAM NUT 5/16”
RT-20 Requires:
PART No. QTY DESCRIPTION
615006 1 ANTI-ROTATION BLOCK
700534 2 LOCK WASHER 10mm
670175 2 SCREW SOCHD M10 X 40mm
610663 2 SET SCREW 5/16” X 1”
610664 2 JAM NUT 5/16”