Paxton Superchargers Dodge SRT-10 Ram - Manual (Page 4)

iv
P/N: 4809645
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
16JAN06 v1.2 SRT-10(4809645v1.2)
B efore beginning this installation, please
read through this entire instruction book-
let and the Street Supercharger System
Owner's Manual which includes the Automotive
Limited Warranties Program and the Warranty
Registration form.
Paxton supercharger systems are performance
improving devices. In most cases, increases in
torque of 30-35% and horsepower of 35-45% can
be expected with the boost levels specified by
Paxton Automotive. This product is intended for
use on healthy, well maintained engines.
Installation on a worn-out or damaged engine is
not recommended and may result in failure of the
engine as well as the supercharger. Paxton
Automotive is not responsible for engine damage.
Installation on new vehicles will not harm or
adversely affect the break-in period so long as fac-
tory break-in procedures are followed.
For best performance and continued durability,
please take note of the following key points:
1. Use only premium grade fuel 91 octane or
higher (R+M/2).
2. The engine must have stock compression
ratio.
3. If the engine has been modified in any way,
check with Paxton prior to using this prod-
uct.
4. Always listen for any sign of detonation
(pinging) and discontinue hard use (no boost)
until problem is resolved.
5. Perform an oil and filter change upon com-
pletion of this installation and prior to test
driving your vehicle. Thereafter, always use a
high grade SF rated engine oil or a high qual-
ity synthetic, and change the oil and filter
every 3,000 miles or less. Never attempt to
extend the oil change interval beyond
3,000 miles, regardless of oil manufactur-
er's claims as potential damage to the
supercharger may result.
RECOMMENDED TOOLS
FOR INSTALLATION:
1. Factory Repair Manual
2. 3/8" Socket and Drive Set: SAE & Metric
3. 1/2" Socket and Drive Set: SAE & Metric
4. 3/8" NPT Tap and Handle
5. Adjustable Wrench
6. Combination Wrench: SAE and Metric
7. Center Punch
8. Springlock 3/8" and 5/16" Fuel Fitting
Disconnect Tool
9. 10 Quarts SH/CF Rated Quality Engine Oil
10. Oil Filter and Wrench
11. Flat #2 Screwdriver
12. Phillips #2 Screwdriver
13. Heavy Grease
14. Silicone Sealer
15. Drill Motor / Pneumatic Right Angle
16. 1/4" Drill Bits
17. Stepless Clamp Pliers
18. 3/16" Allen Wrench
19. Wire Strippers and Crimpers
20. Utility Knife
21. Pliers
22. Threadlocker (Blue)
23. Thread Sealant
24. Fuel Pressure Gauge
Prior to installation it will be necessary to
replace original spark plugs with spark plugs
noted below:
25. Spark Plug Socket
26. NEW Spark Plugs (NGK ZFR6F-11)
2004/2005 Dodge SRT-10 Truck