Paxton Superchargers Dodge SRT-10 Ram - Manual (Page 28)

7-4
P/N: 4809645
©2006 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
16JAN06 v1.2 SRT-10(4809645v1.2))
Fig. 7-l
Fig. 7-m
Fig. 7-n
Fig. 7-o
D. Locate the red wire at terminal # 30 on the
relay (12V power). Route this wire through
the factory wire loom that is running across
the fire wall. (See Fig. 7-m.) Attach the fuse
link with a butt connector and ring terminal
to the 12V terminal at the fuse box. (See
Fig. 7-n.)
E. The wire at terminal #86 (relay trigger) will
be attached in a later step of the installation.
(See Fig. 7-o and Appendix A-4. for refer-
ence)
F. Attach the ground wire at the charge cooler
water pump to one of the screws that retain
the water reservoir to the chassis.
7.4 WATER PUMP RELAY
INSTALLATION
A. Locate the group of wires next to the fire
wall. Attach the relay with the fastener pro-
vided. (See Fig. 7-l.)
B. Route the long red wire #87 on the relay to
the water pump and attach to the green wire
with the blue stripe using a solderless con-
nector.
C. Attach the black wire #85 (relay ground) to
the screw securing the factory ground wires
in place. (See Fig. 7-l.)
FACTORY GROUND
FACTORY WATER
PUMP RELAY
FACTORY WIRE LOOM
TRIGGER
(FROM FACTORY
ECU PIN) #2 PINK
& GREY WIRE ON
ECU
POWER SUPPLY
(RED WIRE FROM
TERMINAL ON FUSE BOX)
GROUND
(TOFACTORY
GROUND SCREW )
NOT USED
POWER TO WATER PUMP
(RED WIRE)
85
30
87
87A
86