Paxton Superchargers Mustang Novi 1000 User Manual

Page 8

1-2

P/N: 4809630
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
01APR03 v2.0 86-93Mus(4809630 v2.0)

Loosen the clamp securing the mass air flow
sensor to the rubber sleeve at the air filter
assembly. Unplug the sensor and un-bolt it
from the strut tower with a 7/16" socket.

Using a 7/16" deep socket, loosen the nuts
securing the air filter assembly to its rubber
mounts and remove the filter from the vehi-
cle. Unscrew the rubber mounts from the
inner fender. (See Fig. 1-d.)

Using a 19mm wrench, loosen the bolt
securing the accessory drive belt tensioner
to the factory bracket and remove the ten-
sioner from the bracket. (See Fig. 1-e.)

Fig. 1-d

Fig. 1-e

Unplug the electrical connection at the alter-
nator, and using a 9/16” and a 1/2” socket,
remove the alternator from the factory
bracket. (See Fig. 1-f.)

Fig. 1-f

Using a 5/16” nut driver, loosen the clamps
and remove the air injection hose from the
smog pump and diverter valve up next to the
valve cover. Disconnect the vacuum line
behind the smog pump and remove the hose
from the vehicle. Set aside for re-use

M. Remove the bolt at the rear of the smog

pump using a 9/16” socket and the two at
the front of the pump, remove the smog
pump from the vehicle.

Using a 9/16” socket and extension, remove
the remaining bolts securing the factory
bracket to the engine. Set the bracket aside,
this bracket will not be re-used, but save it
in a safe place.

Using a 9/16” deep socket and extension,
remove the fuel line bracket from the front
head retaining stud and un-clip it from the
factory fuel lines.

On the frame rail, there is an evaporator
canister. From underneath the vehicle, use a
1/2” socket and remove the two bolts secur-
ing the canister bracket to the frame rail.
Reposition the canister forward, towards the
front of the vehicle, using one of the stock
bolts. Re-attach the canister to the frame rail
using the forward hole in the frame rail and
the rear hole in the bracket.