beautypg.com

Chapter 3: jumpers and switches, Before you begin precautions, Before you begin – NEXCOM VTC 7100-C8SK User Manual

Page 32: Precautions

background image

Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved.

18

Chapter 3: Jumpers and Switches

VTC 71-C Series User Manual

Chapter 3: Jumpers and Switches

This chapter describes how to set the jumpers on the motherboard. Note
that the following procedures are generic for all VTC 71xx-CX series.

Before You Begin

▪ Ensure you have a stable, clean working environment. Dust and dirt can

get into components and cause a malfunction. Use containers to keep
small components separated.

▪ Adequate lighting and proper tools can prevent you from accidentally

damaging the internal components. Most of the procedures that follow
require only a few simple tools, including the following:
– A Philips screwdriver
– A flat-tipped screwdriver
– A set of jewelers screwdrivers
– A grounding strap
– An anti-static pad

▪ Using your fingers can disconnect most of the connections. It is

recommended that you do not use needle-nosed pliers to disconnect
connections as these can damage the soft metal or plastic parts of the
connectors.

▪ Before working on internal components, make sure that the power is off.

Ground yourself before touching any internal components, by touching
a metal object. Static electricity can damage many of the electronic
components. Humid environment tend to have less static electricity than

dry environments. A grounding strap is warranted whenever danger of
static electricity exists.

Precautions

Computer components and electronic circuit boards can be damaged by
discharges of static electricity. Working on the computers that are still
connected to a power supply can be extremely dangerous.

Follow the guidelines below to avoid damage to your computer or yourself:

▪ Always disconnect the unit from the power outlet whenever you are

working inside the case.

▪ If possible, wear a grounded wrist strap when you are working inside the

computer case. Alternatively, discharge any static electricity by touching
the bare metal chassis of the unit case, or the bare metal body of any
other grounded appliance.

▪ Hold electronic circuit boards by the edges only. Do not touch the

components on the board unless it is necessary to do so. Don’t flex or
stress the circuit board.

▪ Leave all components inside the static-proof packaging that they shipped

with until they are ready for installation.

▪ Use correct screws and do not over tighten screws.

This manual is related to the following products: