NEXCOM VTC 6201 User Manual

Page 20

Chapter 1: Product Introduction

VTC 6201 Series User Manual

Startup and Shutdown Mode (Refer to SW2 setting)
The start up and shut down setting modes are as follows.
1. Mode A (default setting). When the input power voltage is 12V, use SW2

to select this voltage. Use the BIOS to select the start up and shut down
voltages.

2. Mode B. When the input power voltage is 24V, use SW2 to select this

voltage. Use the BIOS to select the start up and shut down voltages.

3. Mode C. When the input power voltage is 48V, use SW2 to select this

voltage. Use the BIOS to select the start up and shut down voltages.

Vehicle PC Mode
Mode A (default setting). When the ignition is from “low” to “high”,
VTC 6201 / VTC 6201-M will turn on automatically. When the ignition is
“high”, press the power button to turn off VTC 6201 / VTC 6201-M.

When the ignition is from “high” to “low”, VTC 6201 / VTC 6201-M will
turn off automatically.

Getting to Know VTC 6201 / VTC 6201-M

Front Panel

WiFi/Bluetooth module
antenna mounting holes

GPRS/UMTS/HSDPA module
antenna mounting

Power button

LEDs

USB

SIM card socket

Line-out

Mic-in