Installing the sodimm – NEXCOM VTC 6201 User Manual

Page 61

Text mode
Original mode

Chapter 3: System Setup

VTC 6201 Series User Manual

1. Insert the module into the socket at an approximately 30 degrees angle.

Apply firm even pressure to each end of the module until it slips into the
socket. The gold-plated connector on the edge of the module will almost
completely disappear inside the socket.

SODIMM socket

SODIMM

2. Push the module down until the clips on both sides of the socket lock

into position. You will hear a distinctive “click”, indicating the module is
correctly locked into position.

Clip

Installing the SODIMM