NEXCOM IPPC 1560T - Manual (Page 118)

Copyright © 2014 NEXCOM International Co., Ltd. All Rights Reserved. 101 IPPC 1560T/1960T/2160P Series User Manual
Chapter 4: BIOS Setup
Advanced
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Determines how SATA
controller(s) operate. SATA Controller(s)
SATA Mode Selection
Serial ATA Port 0
Software Preserve
Serial ATA Port 1
Software Preserve
Serial ATA Port 2
Software Preserve
Serial ATA Port 3
Software Preserve
[Enabled]
[IDE]
Empty
Unknown
Empty
Unknown
8GB SATA Flash (8.0GB
SUPPORTED
Empty
Unknown
IDE
AHCI
RAID
SATA Mode Selection
SATA Mode Selection
Configures the SATA as IDE, AHCI or RAID mode.
IDE This option configures the Serial ATA drives as Parallel ATA
physical storage device.
RAID This option allows you to create RAID or Intel Matrix Storage
configuration on Serial ATA devices.
AHCI This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the storage
driver to enable the advanced Serial ATA features which will
increase storage performance.
Advanced
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enables Legacy USB support.
AUTO option disables legacy
support if no USB devices are
connected. DISABLE option will
keep USB devices available
only for EFI applications.
USB Configuration
USB Devices:
2 Keyboards, 1 Point
Legacy USB Support
Port 60/64 Emulation
[Enabled]
[Enabled]
Legacy USB Support
Enable Enables Legacy USB.
Auto
Disables support for Legacy when no USB devices are connected.
Disable Keeps USB devices available only for EFI applications.
Port 60/64 Emulation
Enables I/O port 60h/64h emulation support. This should be enabled for
complete USB keyboard legacy support for non-USB aware OSes.
USB Configuration
This section is used to configure the USB.