Power consumption management – NEXCOM NISE 3640E User Manual
Page 102
Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.
88
NISE 3640E Series User Manual
Appendix A: Power Consumption
Power Consumption Management
Purpose
The purpose of the power consumption test is to verify the power dissipation
of system, and the loading of power supply.
Test Equipment
PROVA CM-07 AC/DC CLAMP METER
Device Under Test
DUT: sys#1/
Test Procedure
1. Power up the DUT, boot into Windows 7 x64 Ultimate
2. Entering standby mode (HDD power down)
3. Measure the power consumption and record it.
4. Run Burn-in test program to apply 100% full loading
5. Measure the power consumption and record it.
Test Data
Sys #1
(Disabled Turbo Boot)
+24V
Full-Loading Mode
1.61A
Total
38.64W
Standby S3Mode
0.08A
Total
1.92W
This manual is related to the following products: