Neotech Communications HGMC-11S - Manual (Page 2)

HGMC-11S
Hardened 1-port 1000Base-TX to 1000Base-FX SFP Media Converter
2 V1.0
Installation
SFP Transceiver Module
You can select different SFP modules as required (Please refer to our SFP selection list for the appropriate module).
To insert/remove the SFP, the procedures are as follow:
1. On the side panel, insert the SFP module into the
SFP port until it is securely locked.
2. Connect the optical fiber (1/2 core) to the LC
connector(s) of the SFP.
3. To remove the SFP module, press down the lock
of the LC connector of the optical fiber to pull out
the fiber cable.
4. Pull down the SFP lever and hold its position. Pull
out the SFP module from the SFP port.
Setup
a) Connect the Ethernet port of the media converter to a PC or network device with a network cable.
b) Insert the appropriate SFP into the corresponding SFP port. Connect the fiber cable from the remote device
(media converter or switch) to the LC connector of the SFP.
c) After the device is powered on, the PWR indicator will all be on. If the indicators are not on, check the power
supply connection.
d) After all cables are correctly connected, the indicators will be lit as per port status LEDs (page 3).