Lm_lt_op3.pdf, Installation – Junger Audio Transmission processor Level Magic LT User Manual
Page 9

Operation manual Level Magic LT, chapter 3 – Installation
INSTALLATION
The Level Magic
TM
LT Digital Audio Level Processor was carefully
packed at the factory with packaging designed to protect the unit from
rough handling during shipment. Please examine the packaging and its
contents carefully for any signs of physical damage, which may have
occurred in shipment.
The Level Magic
TM
LT Digital Audio Level Processor is classified under
the safety category Schutzklasse 1 in keeping with the VDE 0804
standards and may only be used with power supply installations built
according to these regulations.
Check to insure that the mains supply voltage details printed on the
rear panel are the same as your local mains electricity supply.
The Level Magic
TM
LT Digital Audio Level Processor is equipped with
standard connectors (see Chapter 3).
Before making connections to the Level Magic
TM
LT switch off the
power to all units that you are connecting to the Level Magic
TM
LT.
The Level Magic
TM
LT Digital Audio Level Processor is a standard
19“unit (EIA format). That is 1 RU (44 mm) high. Please allow at least
3“depth in addition for the connectors on the rear panel.
When installing the unit in a 19“ rack the rear side of the unit may need
support, especially when mounting in flight cases.
The Level Magic
TM
LT Digital Audio Level Processor should not be
installed near units which produce strong magnetic fields or extreme
heat. Do not install the audio processor directly above or below power
amplifiers.
If, during operation, the sound is interrupted or displays no longer
illuminate, or if abnormal odor or smoke is detected, immediately
disconnect the power cord plug immediately and contact your dealer or
Jünger Audio.
3.1
UNPACK THE UNIT
3.2
POWER SUPPLY
3.3
CONNECTIONS
3.4
RACK MOUNTING
3.5
OPERATION
SAFETY
3