Lm_lt_op4.pdf, Front and back panel – Junger Audio Transmission processor Level Magic LT User Manual
Page 15

Operation manual Level Magic LT chapter 4 –Location of parts and controls
FRONT AND BACK PANEL
Fig. 1: Front panel of the Level Magic
TM
LT
fig. 2: rear panel Level Magic
TM
LT
4.1.
FRONT PANEL
4.2.
REAR PANEL
4
Bypass-button
If you hold the bypass-button pressed while switching on the unit, the
controller of the DSP will be initialized.
All user presets are overwritten, Parameters will be set to the TV uni
factory default.
BACKUP presets to your PC first!
ON/OFF status LED
GPI TALLY
port port
Analog I/O
Power supply
The green LED left of the Ethernet
connector is a status indicator that
shows if the controller is ready to work
When you press the red button for a short time a
reset of the Unit is performed, as if you had cycled
power off and on.
If you press the red button for a longer time,
the LED will begin to flash and the built-in Web
Controller will be reset. Then the factory default
network configuration of the device will be
restored. If you have changed the IP address of
the unit from that shown on the sticker, you will
not have access via your PC GUI. You will have
to change it again via Jünger terminal ( See
5.1.1).
AES Digital I/O
LAN Ethernet port
USB port