Junger Audio Transmission processor Level Magic LT - Manual (Page 13)

Operation manual Level Magic LT, chapter 3 – Installation
The Level Magic
TM
LT Digital Audio Level Processor is set up and
operated via web interface (Internet Explorer/mozilla firefoxx). The
connection is over Ethernet.
Connector :
RJ 45 with status LEDs
8 pin panel jack
Pin assignment of the connector :
Pin Signal name Functions
1 TX + Ethernet send
2 TX - Ethernet send
3 RX + Ethernet receive
4
5
6 RX - Ethernet receive
7
8
9
Electrical specifications: 100Mbit/s auto negotiation port
This port allows remote control of the Level Magic LT by TCP/IP over
Ethernet.
The controller of the Level Magic
TM
LT acts as a CAN-controller (CAN-
server) for an external client. For details please refer to the Level Magic
LT web interface description (5.2 OPERATION).
For integration of the Level Magic LT into a LAN your unit hass been
given it’s own IP address (shown on a label on the rear of the unit) and
needs to be given a sub net mask of the used LAN.
For network integration of your device refer to 5.1.1 Operation –
Jünger terminal – network integration).
This port allows network configuration and password
administration.
Before you connect the Level Magic LT via USB to your PC
please install the junger terminal (CD-Rom, see 5.1 OPERATION –
junger terminal).
Connector : USB 1.0
USB connector for serial data transfer
3.8
LAN INTERFACE
3.9
USB
CONNECTOR