Junger Audio b42 - Dynamics Processor User Manual
Page 25
4. LOCATION OF PARTS AND CONTROLS
Units with SDI interface can be used in SDI split mode:
Audio in path
SDI input > AES output
Audio out path
SDI output > dsp processing > AES output
(see also 2.5)
dsp
processing
AES
out
SDI
out
SDI
in
B4x
Split Mode
AES
in
External device
AES
in
AES
out
The selection of split mode (SDI DIRECT) is made by switch
SPLIT on in the input (MODE) edit menu.
The 4-channel processors of b40 series fitted with SDI-interface
are compatibel with the standard SMPTE 272M-AB. They
support 48 kHz synchronous audio sampling with 20 bit word
length.
4.4
SELECTION OF
SDI SPLIT MODE
4.5
CONFIGURATION
OF SDI INTERFACE
The standard allows up to four groups each of four mono audio channels.
(Usually used by most of D-VTR's and other equipment is Group 1 with 48
kHz synchronous sampling.)
Group selection and other settings are to configure with settings
by front panel operation (mode section).
Operation manual b42, chapter 4 -location of parts and controls - page 4-5